🔧 How to Install Your PopSocket Adapter

🔧 How to Install Your PopSocket Adapter

3D Creations by Chad | Installation Guide

Whether you're rocking a QuadLock or Rokform setup, this quick guide will get your PopSocket Adapter dialed in and ready to rip.


🎥 Video Walkthrough

Embed YouTube Video – [Watch Now]

Prefer to see it done step-by-step? Click the video above to follow along.


🛠 Step-by-Step Instructions

Step 1: Prep Your PopGrip

If you ordered the pre-installed version — you’re golden.
Otherwise:

  • Remove your swappable PopGrip from its adhesive base.

  • Make sure it's clean and free of gunk or old tape.


Step 2: Lock PopGrip into the Adapter

  • Align the two notches on the PopGrip base with the grooves in the adapter.

  • Press straight down on the PopGrip top.

  • Twist clockwise until you hear/feel it click into place.


Step 3: Mount the Adapter to Your Case

  • Pop the adapter into your QuadLock or Rokform mount just like any official accessory.

  • You’re now free to grip phone like a boss.


🔁 Reinstalling the PopGrip Base (If It Pops Out)

If the swappable base separates from the collapsible section:

👉 Follow this guide: How to Fix a PopSocket

 


👀 If It’s Not Locking In…

  • Check for debris: Clean the adapter and PopGrip base.

  • Try another PopGrip: Some older grips wear out or don’t lock properly.

  • Still loose? Use a small strip of painter’s tape around your case’s mounting point to tighten things up.


💡 Pro Tips

  • Don’t force the twist  the grip should click in smoothly.

  • Want to swap PopGrips often? Keep a spare mounted on a PopGrip coupler  (sold separately).


📬 Still Stuck?

Shoot me a message on Instagram @3dcreationsbychad or email me, I’m happy to help.

Enjoy the ride, and stay securely connected.
— Chad

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.